HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 280)

9-13 TNC 425/TNC 415 B/TNC 407
9 3D Touch Probes
NO
ENT
.
.
.
ENT e.g.
END
0
9.2 Touch Probe Cycles in the MANUAL and ELECTRONIC HANDWHEEL Operating Modes
Select the second coordinate.
DATUM
Enter the second coordinate of the datum, here in the Y axis.
Terminate the probe function.
If you do not wish to use the points that were already probed for a basic rotation:
TOUCH POINTS OF BASIC ROTATION ?
Ignore the previous touch point coordinates.
Probe both workpiece sides twice.
Enter the coordinates of the datum.