HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 359)

12-15
12 Tables and Overviews
TNC 425/TNC 415 B/TNC 407
12.2 Miscellaneous Functions (M Functions)
Miscellaneous functions with predetermined effect
M Function Effective at block Page
start end
M101 Automatic tool change with sister tool
if maximum tool age has expired
• 4-15
M102 Reset M101 • 4-15
M103 Reduce feed rate during plunging to factor F (percentage) • 5-66
M105 Machining with first Kv factor •
M106 Machining with second Kv factor • • • • •
M107 Suppress error message for replacement tools with oversize • 4-15
M108 Reset M107 • • • • •
M109 Constant contouring speed at tool cutting edge on circular arcs
(increase and decrease feed rate)
• 5-67
M110 Constant contouring speed at circular arcs (feed rate decrease only) • 5-67
M111 Reset M109/M110 • 5-67
M112 Automatic insertion of rounding arcs at non-tangential straight-line
transitions; Enter Tolerance T and Limit Angle A for contour deviation
• 5-67
M113 Reset M112 • • • • •
M114 Automatic compensation of machine geometry during operation
with tilting axes
• 5-69
M115 Reset M114 •
M116 Feed rate for angular axes in mm/min • 5-69
M118 Superimpose handwheel positioning during program run • 5-70
M124 Ignore points for calculating the rounding arc with M112 • 5-70
M126 Move rotary axes by shortest path • 5-68
M127 Reset M126 • 5-68
M200 Output programmed voltage directly through S analog (laser cutting) • 5-71
M201 Output voltage as a function of distance through S analog (laser cutting) • 5-71
M202 Output voltage as a function of speed through S analog (laser cutting) • 5-71
M203 Output voltage as a function of time through S analog (ramp, laser cutting) • 5-72
M204 Output voltage as a function of time through S analog (pulse, laser cutting) • 5-72
The miscellaneous functions M105 and M106 are defined and enabled by the machine builder. Please contact your
machine builder for more information.