HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 22)

TNC 425/TNC 415 B/TNC 407 1-21
1 Introduction
Fig. 1.26: Shifting sectional planes
Fig. 1.25: TNC graphics, projection in three planes
or
or
1.4 Graphics and Status Displays
or
Projection in 3 planes
Similar to a workpiece drawing, the part is dis-
played with a plan view and two sectional
planes. A symbol to the lower left indicates wheth-
er the display is in first angle or third angle
projection according to ISO 6433 (selectable via MP
7310).
Details can be isolated in this display mode for
magnification (see page 1–24).
Shifting planes
The sectional planes can be shifted as desired.
The positions of the sectional planes are visible
during shifting.
Shift the soft-key row.
Shift the vertical sectional plane to the right or left.
Shift the horizontal sectional plane upwards or downwards.