C ircle – HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 121

TNC 425/TNC 415 B/TNC 407
5-22
5
Programming Tool Movements
Fig. 5.30:
Coordinates of a circular arc
Path Contours - Cartesian Coordinates
Fig. 5.28:
Circular path from
S
to
E
around CC
CC
E
S
Y
X
CC
E
S
Y
CC
X
CC
X
S
X
E
Y
E
Y
S
Fig. 5.29:
Full circle around CC with a
C block
Y
X
CC
S
E
Circular path C around the circle center CC
Prerequisites
The circle center CC must have been previously defined in the program.
The tool is located at the circle starting position
S
.
Input
• Arc end point
• Direction of rotation DR
The starting and end points of the arc must lie on the circle.
Input tolerance: up to 0.016 mm (selectable with MP 7431).
• To program a full circle, enter the same point for
the end point as for the start point in a C block.
See also other documents in the category HEIDENHAIN Equipment:
- TNC 122 User Manual (63 pages)
- TNC 122 Technical Manual (70 pages)
- TNC 360 Service Manual (157 pages)
- TNC 416 Technical Manual (510 pages)
- TNC 335 Technical Manual (581 pages)
- TNC 360 User Manual (237 pages)
- TNC 360 ISO-Programmierung (2 pages)
- TNC 415 (280 540) User Manual (227 pages)
- TNC 370D (92 pages)
- TNC 416 (289 pages)
- TNC 415 (280 540) Technical Manual (752 pages)
- TNC 415 (259 96x) Service Manual (195 pages)
- iTNC 530 (340 420) Pilot (104 pages)
- TNC 407 (280 580) ISO Programming (333 pages)
- TNC 415 (280 540) Service Manual (252 pages)
- PT 880 Installation (112 pages)
- ND 100 User Manual (116 pages)
- ND 287 User Manual (147 pages)
- ND 280 Quick Start (12 pages)
- ND 200 (156 pages)
- ND 282 (10 pages)
- ND 287 Quick Start (26 pages)
- ND 282 B (39 pages)
- ND 281 A (44 pages)
- ND 281 B v.1 (53 pages)
- ND 281 B v.2 (65 pages)
- ND 221 v.2 (10 pages)
- ND 231 B v.2 (56 pages)
- ND 231 B v.1 (44 pages)
- ND 221 B v.2 (45 pages)
- ND 550 v.2 (8 pages)
- NDP 560 (10 pages)
- ND 523 (93 pages)
- ND 570 (8 pages)
- ND 750 v.2 (46 pages)
- ND 760 v.3 (72 pages)
- ND 770 v.1 (40 pages)
- ND 770 v.3 (41 pages)
- ND 760 E (44 pages)
- IOB 49 (21 pages)
- NDP 960 (68 pages)
- ND 780 Installation (132 pages)
- ND 970 (47 pages)
- ND 1100 Quick Start (36 pages)