HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 358)

12-14
12 Tables and Overviews
TNC 425/TNC 415 B/TNC 407
12.2 Miscellaneous Functions (M Functions)
Miscellaneous functions with predetermined effect
M Function Effective at block Page
start end
M00 Stop program run/Spindle STOP/Coolant OFF • 3-5
M02 Stop program run/Spindle STOP/Coolant OFF/
Clear status display (depending on machine parameter)/Go to block 1
• 3-5
M03 Spindle ON clockwise •
M04 Spindle ON counterclockwise •
M05 Spindle STOP •
M06 Tool change/Stop program run (depending on machine parameter)/
Spindle STOP
• 3-5
M08 Coolant ON •
M09 Coolant OFF •
M13 Spindle ON clockwise/Coolant ON •
M14 Spindle ON counterclockwise/Coolant OFF •
M30 Same function as M02 • 3-5
M89 Vacant miscellaneous function or •
Cycle call, modally effective (depending on machine parameter) • 8-3
M90 Constant contouring speed at corners (effective only in lag mode) • 5-62
M91 Within the positioning block: Coordinates are referenced to machine zero • 5-65
M92 Within the positioning block: Coordinates are referenced to position
defined by machine builder, such as tool change position
• 5-65
M93 Reserved •
M94 Reduce display of rotary axis to value less than 360° • 5-70
M95 Reserved •
M96 Reserved •
M97 Machine small contour steps • 5-63
M98 Completely machine open contours • 5-64
M99 Blockwise cycle call • 8-3