HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 132)

5-33 TNC 425/TNC 415 B/TNC 407
5 Programming Tool Movements
P
ENT
5 e.g.
0 3 e.g. ENT
5.5 Path Contours - Polar Coordinates
L COORDINATES ?
Select polar coordinates.
POLAR COORDINATES-RADIUS PR ?
Enter the radius from the pole to the straight line end point, for
example PR = 5 mm.
POLAR COORDINATES-ANGLE PA ?
Enter the angle from the reference axis to PR, for example PA = 30°.
If necessary, enter:
Radius compensation R
Feed rate F
Miscellaneous function M
Resulting NC block: LP PR+5 PA+30