beautypg.com

HEIDENHAIN TNC 407 (280 580) User Manual User Manual

Page 249

background image

8-42

8

Cycles

TNC 407/TNC 415 B/TNC 425

Input data

• MILLING DEPTH Q1:

Distance between the cylindrical surface and the floor of the contour.

• ALLOWANCE FOR SIDE Q3:

Finishing allowance in the plane of the unrolled cylindrical surface.
This allowance is effective in the direction of the radius compensation.

• SETUP CLEARANCE Q6:

Distance between the tool tip and the cylinder surface.

• PECKING DEPTH Q10:

Dimension by which the tool advances in each infeed.

• FEED RATE FOR PECKING Q11:

Feed rate for traversing in the tool axis.

• FEED RATE FOR MILLING Q12:

Feed rate for traversing in the working plane.

• RADIUS Q16:

Radius of the cylinder on which the contour is to be machined.

• DIMENSION TYPE (ANG/LIN) Q17:

The dimensions for the rotary axis of the subprogram are given either
in degrees (0) or in mm/inch (1).

Prerequisites

• The cycle requires a center-cut end mill (ISO 1641).

• The cylinder must be set up centered on the rotary table.

• The tool axis must be perpendicular to the rotary table axis. If this is

not the case, an error message will result.

8.4

SL Cycles (Group II)