HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 300)

9-33 TNC 425/TNC 415 B/TNC 407
9 3D Touch Probe Systems
0 e.g.
TOUCH
PROBE
GOTO 7
ENT
ENT
1
ENT
e.g. X 0 Y 0
ENT
e.g. Y
e.g. X
ENT
ENT
e.g. 0
ENT
2
ENT
e.g. 1 0 0 0
.
.
.
9.4 Digitizing with a Measuring Touch Probe
STARTING PROBE AXIS AND DIRECTN ?
Enter the starting direction, for example X–.
FEED RATE ? F
Enter the digitizing speed, for example 1000 mm/min.
MIN. LINE SPACING ?
Enter the minimum spacing between lines, for example 0.2 mm.
STARTING POINT ?
Enter the coordinates of the starting position, for example X+0, Y+0.
To program TCH PROBE 7.0:
TCH PROBE 0 REF. PLANE
Select the scanning cycle 17: CONTOUR LINES.
TCH PROBE 17 CONTOUR LINES
Confirm your selection.
TIME LIMIT ?
Enter the time limit within which one contour must be scanned, for
example 0 seconds (no time limit).
AXIS AND DIRECTION OF APPROACH ?
Enter the approach direction, for example Y–.