HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 73
TNC 425/TNC 415 B/TNC 407
4-14
4
Programming
Fig. 4.8:
Pocket table for the tool changer
Pocket table for tool changer
The TOOL_P table (for tool pocket) is programmed
in a program run operating mode.
The NEW POCKET TABLE or also the RESET POCKET
TABLE soft key is for erasing an existing pocket table
and writing a new one. Like the tool table, a pocket
table can also be read-in and read-out directly through
the data interface (see page 4-11).
To select the pocket table:
Select tool table.
Select pocket table.
Set the EDIT soft key to ON.
To edit the pocket table:
Abbrev.
Input
Dialog
P
Pocket number of the tool in the tool magazine
–
T
Tool number
TOOL NUMBER
F
Fixed tool number. The tool is always returned to the same pocket.
FIXED TOOL
YES = ENT / NO = NOENT
L
Locked pocket
POCKET LOCKED
YES = ENT / NO = NOENT
ST
Special Tool
If this ST requires also the pockets in front of and behind
its own pocket, then lock the appropriate number of pockets.
SPECIAL TOOL
PLC
Information on this tool that should be sent to the PLC
PLC STATUS
Overview: Data in the pocket table