beautypg.com

8 selecting the unit of measure, 9 selecting the programming language for $mdi, 10 selecting the axes for generating l blocks – HEIDENHAIN TNC 407 (280 580) User Manual User Manual

Page 343

background image

11-10

11

MOD Functions

TNC 425/TNC 415 B/TNC 407

11.8 Selecting the Unit of Measure

This MOD function determines whether coordinates are displayed in
millimeters (metric system) or inches.

• To select the metric unit system (e.g., X = 15.789 mm),

set the CHANGE MM/INCH function to MM.
The value is displayed with 3 digits after the decimal point.

• To select the inch system (e.g., X = 0.6216 inch),

set the CHANGE MM/INCH function to INCH.
The value is displayed with 4 digits after the decimal point.

11.9 Selecting the Programming Language for $MDI

The PROGRAM INPUT mod function lets you decide whether to program
the $MDI file in HEIDENHAIN conversational dialog or in G-codes accord-
ing to ISO.

• To program the $MDI.H file in conversational dialog,

set the PROGRAM INPUT function to HEIDENHAIN.

• To program the $MDI.I file according to ISO,

set the PROGRAM INPUT function to ISO.

11.10 Selecting the Axes for Generating L Blocks

The AXIS SELECTION input field enables you to define the current tool
position coordinates that are transferred to an L block. To generate a
separate L block, press the ACTUAL POSITION CAPTURE soft key (see
page 4-30). On the TNC 407, up to 3 coordinates can be transferred; on
the TNC 415 B and TNC 425 controls, you can transfer up to 5 coordi-
nates. The axes are selected by bit-oriented definition, similar to program-
ming the machine parameters.

AXIS SELECTION

%11111

Transfer the X, Y, Z, IV, and V axes

AXIS SELECTION

%01111

Transfer the X, Y, Z, and IV axes

AXIS SELECTION

%00111

Transfer the X, Y, and Z axes

AXIS SELECTION

%00011

Transfer the X and Y axes

AXIS SELECTION

%00001

Transfer the X axis