HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 34)

TNC 425/TNC 415 B/TNC 407 1-33
1 Introduction
1.6 Files
PGM
NAME
File status
The letters in the STATUS column give the following information about the
files:
E: File is selected in the PROGRAMMING AND EDITING mode of
operation
S: File is selected in the TEST RUN operating mode
M: File is selected in a program run operating mode
P: File is protected against editing and erasure
IN: File contains inch dimensions
W: File has been transferred to external storage and cannot be run
Selecting a file
Call the file directory.
At first only HEIDENHAIN dialog (type .H) files are shown. Other files are
shown via soft key:
Select the file type.
Show all files.
You select a file by moving the highlight bar:
Function Key / Soft key
• Move the highlight bar vertically
to the desired file
• Move pagewise down/up
through the file directory
• Select the highlighted file