El. handwheel – HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 41

TNC 425/TNC 415 B/TNC 407
2-3
2
Manual Operation and Setup
Using the HR 330 electronic handwheel
The HR 330 is equipped with an enabling switch. The enabling switch is
located opposite the side with the knob and the EMERGENCY STOP
switch. The machine axes can only be moved when the enabling switch is
depressed.
• The enabling switch is automatically depressed when the handwheel is mounted on the machine.
• Mount the handwheel on the machine on the magnetic pads such that it cannot be operated unintentionally.
• When you remove the handwheel from its position, be careful not to accidentally press the axis direction keys
while the enabling switch is still depressed.
ENT
X
3
e.g.
e.g.
Traversing with the electronic handwheel:
ELECTRONIC HANDWHEEL
INTERPOLATION FACTOR:
X =
3
Enter the interpolation factor (see table).
Select the axis that you wish to move: for portable handwheels at the
handwheel, for integral handwheels at the TNC keyboard.
Now move the selected axis with the electronic handwheel. If you are
using the portable handwheel, first press the enabling switch on its side.
Fig. 2.2:
HR 330 electronic handwheel
Fig. 2.1:
Interpolation factors for handwheel speed
Traverse in mm per
revolution
20.000
10.000
5.000
2.500
1.250
0.625
0.312
0.156
0.078
0.039
0.019
The smallest programmable interpolation factor depends on the individual machine tool. See your machine tool
manual.
It is also possible to move the axes with the handwheel during a program run (see page 5-70).
Interpolation
factor
0
1
2
3
4
5
6
7
8
9
10