HEIDENHAIN TNC 407 (280 580) User Manual User Manual

Page 330

10-4

External Data Transfer

TNC 425/TNC 415 B/TNC 407

Fig. 10.1:

Menu for blockwise transfer

When aborting blockwise transfer, you may have to reset the interface with the CLOSE RS-232-C soft key.

Transferring files from an external device to the TNC

Use the cursor key to move the highlight to a file that is stored in the
external device.

Function

Key

• Transfer the selected file

• Transfer all files

• Select files consecutively for individual

transfer. To transfer, press ENT, other-
wise NO ENT

Interrupt transfer

You can interrupt data transfer by pressing the END key or the END soft
key.

• If the TNC recognizes erroneously transferred program blocks, it will mark them with ERROR =.

These blocks must then be corrected in the PROGRAMMING AND EDITING mode.

• If you want to transfer files between two TNCs, start transmission from the receiving TNC.

Blockwise transfer

The menu to the right is for blockwise transfer (see
page 3-11). First select as usual the name of the file
to be transferred blockwise. Then start data
transfer with the SELECT soft key.