HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 336)

11-3
11 MOD Functions
TNC 425/TNC 415 B/TNC 407
MOD
ENT
5 e.g.
END
or
ENT
Repeatedly
If necessary
11.1 Selecting, Changing and Exiting the MOD functions
To select the MOD functions:
Change to the desired mode of operation.
Select MOD functions.
To change the MOD functions:
Use the arrow keys to move the highlight to the desired MOD function.
Page through the MOD functions until you find the desired function.
Enter the appropriate numbers and confirm entry with ENT.
To exit the MOD functions:
Close the MOD functions.
11.2 Software Numbers and Option Numbers
The software numbers of the NC and PLC are displayed immediately in
the MOD function opening screen. Directly below them are the code
numbers for the installed options (OPT:).
• Digitizing option OPT: 1
• Digitizing and measuring touch probe options OPT: 11
11.3 Code Number
The TNC asks for a code number before it grants access to certain
functions:
Function Code number
To cancel file erase and edit protection (status P) 86357
To select user parameters 123