HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 49)

TNC 425/TNC 415 B/TNC 407 2-11
2 Manual Operation and Setup
e.g.
2.4 Tilting the Working Plane (not on TNC 407)
To activate manual tilting
Select menu for manual tilting.
Select the tilt axis.
Enter the tilt angle, here 45°.
Set TILT WORKING PLANE to ACTIVE.
Terminate input.
A symbol for the tilted plane is shown in the status display whenever the
TNC is moving the machine axes in the tilted plane.
To reset
Set TILT WORKING PLANE to INACTIVE.
oder
4 5
ENT
ENT
If you set the function TILT WORKING PLANE for the operating mode PROGRAM RUN to ACTIVE, the tilt angle
entered in the menu becomes active in the first block of the part program. If you are using cycle 19 WORKING
PLANE in the part program, the angle values defined in the cycle (starting at the cycle definition) are effective. Angle
values entered in the menu will then be overwritten.
Fig. 2.7 : Menu for manual tilting in the MANUAL
OPERATION mode