Rockwell Automation FactoryTalk View Site Edition Users Guide - Manual (Page 40)

F ACTORY T ALK V IEW S ITE E DITION U SER ’ S G UIDE
1–14
• •
•
•
•
Step 3: Test run the application in FactoryTalk View SE Client
In FactoryTalk View Studio, you can only test one graphic display at a time. To test
navigating among displays, run the application in a FactoryTalk View SE Client.
To run the new application you just created, create a FactoryTalk View SE Client
configuration file that specifies:
 The type and name of the application the client will connect to.
 The display to run initially, when the client starts. This can be the new display you just
created.
To create a FactoryTalk View SE Client configuration file
1. Select Start > All Programs > Rockwell Software > FactoryTalk View >
FactoryTalk View Site Edition Client.
2. In the FactoryTalk View SE Client Wizard, click New, and then follow the instructions
in the wizard.
For details about options in the FactoryTalk View SE Client Wizard, click Help.
To run the FactoryTalk View SE Client
1. In the Completion Options window of the FactoryTalk View SE Client Wizard, select
Save configuration and open FactoryTalk View SE Client now.
2. Click Finish.
The graphic display you specified to run initially will open in the FactoryTalk View
SE Client window.
When you are finished testing, use the close button on the client’s title bar to close the
client window.
While you are developing an application, it is recommended that you test run the application in a
FactoryTalk View SE Client at various stages. That way, you can resolve issues that might occur
only at run time.