Lenze Engineer v2.21 - Manual (Page 98)

Device functions with active online connection
98
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7 Device functions with active online connection
This chapter describes how you can do the following when an online connection to a device has
been established:
• Executing control functions such as "Start program" or "Inhibit controller" in the device via the
»Engineer«
• Transferring parameter settings of the »Engineer« project (and optionally the drive application)
to the device.
• Transferring the parameter settings currently stored in the device to the »Engineer« project.
Overview of device functions in the online mode

Tip!
Detailed information on how to establish an online connection to the device is provided in
the following section: " Establishing an online connection ". ( 75)
Device function Devices supported
Inverter
Drives 8400
Servo Drives
9400
Controller I/O system
Controlling an inverter: Enable/inhibit, start stop application ( 100)
Enable controller ( 100)   - -
Inhibit controller ( 101)   - -
Start application ( 101) -  - -
Stop application ( 101) -  - -
Application and parameter set transfer ( 102)
Download program to device ( 103) -  - -
Download parameter set to device ( 105)    
Upload parameter set ( 106)    
Save parameter set ( 107)    -
Diagnostics ( 110)    
Data logger ( 111)   - 
Oscilloscope ( 127)   - -