Lenze Engineer v2.21 - Manual (Page 189)

Lenze · Engineer · 2.13 EN - 10/2014
189
Defining the system functionality
Creating an interconnection via the electrical shaft
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• In the Interconnection tab, all the axes that have been assigned to the electrical shaft are
shown. In the Interconnection tab, you can:
• Assign additional axes to the interconnection.
•
Adding placeholders to the interconnection ( 190)
• Assigning an axis to a placeholder ( 191)
• Cancelling existing assignments ( 193)
• In the Measuring systems tab all measuring systems available are shown. In the Measuring
systems tab you can:
• Creating/editing/deleting measuring systems ( 199)
• In the Cam Manager tab, you can:
• Managing cam data with the »Cam Manager« ( 272)
• Creating cam data with the »Cam Editor« ( 279)
• In the Connections tab, the connections of the ports which are relevant for the electrical shaft
and via which the master value/master angle is transferred are shown.