Lenze Engineer v2.21 - Manual (Page 133)

Lenze · Engineer · 2.13 EN - 10/2014
133
Defining the system functionality
Assigning an application to the device
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.5 Assigning an application to the device
If you insert a device, you can optionally select an application available for the corresponding device
after having selected the device to be inserted.
• You can replace the application assigned to the device with another application that is available
for the device any time:

How to replace an application:
1. Select the controller under which the application to be replaced is located in the Project
view.
2. Select the menu command InsertApplication.
• As an alternative, execute the Insert application command in the context menu of the
drive controller.
• The Insert application dialog box appears.
3. Select the new application.
4. Press OK.
5. Confirm safety query with Yes to replace the existing application with the application
selected.
• The dialog box is closed and the previous application is replaced with the application you
have just chosen.
• The application selected, "Actuator -
speed", is attached to the device (9400
HighLine) in the Project tree:
• If, during insertion, an application is not
selected for the device, a so-called "empty
application" is assigned to the device.

Note!
If an application is replaced, the present parameterisation, configuration, and the
program for the device are lost!