Lenze Engineer v2.21 - Manual (Page 254)

Error messages
Communication entity generator
254
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Error during writing of parameter value {0} [CE94CAN0003]
Node with SYNC source property must be NMT master [CE94CAN0004]
Predefined connection set active [CE94CAN0005]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Parameter value could not be written to the code.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
A special feature of the 9400 is that, when it is to send a
synchronisation object, it must be the NMT master at the
same time.
• Go to the network which is assigned to the device.
• Highlight the corresponding node in the Node tab.
• The node is enclosed in green.
• Select
Set NMT master from the context menu of the right
mouse button.
• The master node has a black triangle in the right
corner at the bottom.
Nodes ( 216)
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Node is not connected to a CAN network. In the Settings
tab of the node, the control field Use Predefined
Connection Set was selected. During the compilation,
the settings for COB-IDs, SYNC, etc. were assigned in
accordance with CANopen.
This message is information for the user.