Lenze Engineer v2.21 - Manual (Page 245)

Lenze · Engineer · 2.13 EN - 10/2014
245
Error messages
CAN generator
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Error during reading of the NMT master settings [NWCAN0010]
12.3.3 Synchronisation
SYNC master not defined [NWCAN0011]
SYNC transmission identifier {0} is not supported by node [NWCAN0012]
SYNC transmission cycle time {0} ms is not supported by node [NWCAN0013]
SYNC reception identifier {0} is not supported by the nodes [NWCAN0014]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The access to the NMT master settings has failed.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
In the specified network either process data objects or
processes (tasks) are connected to the synchronisation
object. However, no synchronisation object generator is
defined.
• Change to the Synchronisation tab of the network
specified.
• Under SYNC source, select the node the
synchronisation object is to send cyclically.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The indicated SYNC source does not support the
indicated COB-ID.
Select a COB-ID under SYNC source in the
Synchronisation tab of the network specified which
supports all nodes. (E. g: 128).
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The indicated SYNC source does not support the
specified cycle time for sending the synchronisation
object.
Select a cycle time under SYNC source in the
Synchronisation tab of the network specified which
supports all nodes.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The SYNC receiver specified does not support the defined
COB-ID.
Select a COB-ID under SYNC source in the
Synchronisation tab of the network specified which
supports all nodes. (E. g: 128).