Lenze Engineer v2.21 - Manual (Page 74)

Mapping the system structure in the »Engineer« project
Protecting safe parameters - project-related password entry
74
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.8 Protecting safe parameters - project-related password entry
This function is available from »Engineer« HighLevel V2.14!
The »Engineer« provides a password protection which serves to protect the parameter setting of the
higher-order safety functions from alterations in the project for the device series 8400 and 9400.
The password...
• ... can be set on the Protection tab if the project root has been selected in the project tree.
• ...is only valid inside the project (no transmission to the controller or safety module). If a
password is stored in the project and this project is used, the safe parameters can only be edited
after the password has been entered.

How to activate the protection of the save parameters:
1. Select the project root in the project tree.
2. Assign the desired password on the Protection tab.
• After the password has been set, the safe parameters (tab Safe configuration, safe
parameters) of all included devices can only be edited inside the project after the
corresponding password has been entered.