Lenze Engineer v2.21 - Manual (Page 247)

Lenze · Engineer · 2.13 EN - 10/2014
247
Error messages
CAN generator
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Invalid value range for COB-ID (min and max inverted?) [NWCAN0019]
COB-ID beyond the limits. Generate new COB-ID for PDO [NWCAN0020]
COB-ID is used more than once [NWCAN0021]
COB-ID {0} outside the value range [NWCAN0028]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The data for the automatically allocated COB-ID range
are incorrect.
• Change to the Settings tab of the network specified.
• Set a range in the Automatically allocate identifier
group field supporting all devices connected to the
network.
• Set from < to.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
During checking the COB-IDs it was observed that the
COB-ID of the process data object specified (associated
port) is beyond the COB-ID range defined under the
network settings. A new COB-ID is generated for the
process data object specified.
Ignore warning. In the case of time-critical processes,
however, the COB-IDs allocated in the CAN objects tab of
the network should be checked and possibly adjusted.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Generate new COB-ID for PDO
During checking the COB-IDs it was observed that the
COB-ID of the process data object specified (associated
port) has already been allocated. A new COB-ID is
generated for the process data object specified.
Ignore warning. In the case of time-critical processes,
however, the COB-IDs allocated in the CAN objects tab of
the network should be checked and possibly adjusted.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
An attempt is made to transfer the COB-ID of the sender
to the receiver of project data objects. When this was
done, an error occurred. It is possible that the COB-ID is
outside the valid value range.
Check value range of the COB-ID.