Lenze Engineer v2.21 - Manual (Page 170)

Defining the system functionality
User menu
170
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.12 User menu
When a system is set up, parameters must be changed again and again until the system operates
satisfactorily. In the User menu of a device, you can arrange a selection of frequently used
parameters in order to be able to quickly access and change these parameters.

How to show the user menu:
Select the User menu tab at the bottom of the application window to show the User menu:
• The pre-assignment of the User menu depends on the selected device
(here: 8400 StateLine C).
• In the case of the Servo Drives 9400 series the User menu is empty at first.

Tip!
The User menu can also be displayed in the Workspace by changing to the User menu tab:
The buttons of this tab serve to configure the User menu and transfer the parameter
selection to other controllers.

Note!
The User menu is available for controllers of the 8400 and 9400 device series!