Lenze Engineer v2.21 - Manual (Page 252)

Error messages
Communication entity generator
252
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.4.2 Compact (8200)
Unexpected error [CECOMP0001]
Different transfer modes for CAN1 IN/OUT [CECOMP0002]
COB-ID {0} has been assigned several times for nodes [CECOMP0003]
Baud rate of {0}k is not supported by node [CECOMP0004]
Error during writing on object [CECOMP0005]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The transfer modes have been coupled for the CAN1
objects of the controller.
CAN1-IN and CAN1-OUT have to be transferred in a
synchronised manner or asynchronously.
The following combinations are permissible:
CAN1-IN
CAN1-OUT
Synchronous Synchronous
Asynchronous Time or event
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Assigning the same COB-ID several times for fixed
process data objects is not allowed for a 9300.
Ensure that no ports of a 9300 device are connected to
each other in the function block editor.
By this, the ports would receive the same COB-IDs.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The baud rate cannot be transferred to the associated
code.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Object could not be written.