Lenze Engineer v2.21 - Manual (Page 238)

Error messages
Application Connection Generator
238
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12 Error messages
This chapter describes the generators and their error messages that are called during the "Create"
process ( Build project ). The error messages are visible in the Create tab and are divided into different
categories: Error, warning, information.
 Application Connection Generator ( 238)
 PortLogic generator ( 241)
 CAN generator ( 243)
 Communication entity generator ( 249)
12.1 Application Connection Generator
Checking the connection between the port and the process data object
Dynamic creation of a PDO [AC0001]
Dynamic PDO for a port cannot be created [AC0002]
Dynamic ProcessDataObject for port cannot be created [AC0003]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
A port has not been specified by the user but has been
interconnected with another device. An attempt is made
to create a dynamic PDO for this port.
Check transfer parameters with the settings in the
application.
 Process data objects ( 226)
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Communication entity not found
A port has not been specified but has been
interconnected with another device. An attempt is made
to create a dynamic PDO for this port. However, this
attempt fails because the device has no or several
communication interfaces.
Apply the port to a specific interface in the port editor.
 Port editor (ports) ( 155)
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Communication entity not found
A port has not been specified but has been
interconnected with another device. An attempt is made
to create a dynamic PDO for this port. However, this
attempt fails because the device has no or several
communication interfaces.
Device is not provided with an interface enabling the
dynamic creation of a PDO, or the supply is used up.
• Apply port to a fixed PDO (8200 and 9300), or
• convert unused, unconnected ports to automatic
ports.