Lenze Engineer v2.21 - Manual (Page 85)

Lenze · Engineer · 2.13 EN - 10/2014
85
Establishing an online connection
Going online
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.2.1.5 PROFINET
For the Servo Drives 9400 device series a PROFINET communication module is provided,
by means of which you can establish an online connection to a field device via PROFINET.
6.2.1.6 Gateway controller -> CAN
The controller offers a gateway function to establish an online connection to a field device via CAN.

How to configure an online connection to a field device which is connected to the
controller via CAN:
1. Go to the Communication path dialog box and select the entry "Gateway controller -> CAB"
from the Bus connection list field.
2. Press Search/Enter....
• The Gateway controller -> Set up CAN system bus dialog box is shown:
3. Enter the IP address of the controller.
• By pressing Ping you can carry out a simple test on whether a device can actually be
reached via the IP address set.
Please note: However, this has not necessarily got to mean that the intended device can
be reached via this IP address!

More information on Parameter setting & configuration with PROFINET can be found in
the PROFINET communication manual , section "Establish online connection via PROFINET
using the Lenze »Engineer«"