Lenze Engineer v2.21 - Manual (Page 211)

Lenze · Engineer · 2.13 EN - 10/2014
211
Inserting & configuring a network
ETHERNET Powerlink network
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Working in the network view
In the upper position, the network view is provided with an individual toolbar.
• Click on an icon to execute the corresponding function.
Context menu in the network view
The Network view furthermore provides you with a Context menu for each node, featuring the
following commands:
Icon Menu command Function
Network  Insert node Inserting nodes ( 218)
Network  Remove node Removing nodes ( 220)
Network  Node settings Node settings ( 219)
- Sort the nodes according to address
Network  Zoom in view Increase the size of the information shown in the Nodes tab
Network  Zoom out view Reduce the size of the information shown in the Nodes tab
Network  Overview Show overview window
Network  Whole worksheet Adapt the information shown to the whole worksheet
Network  Page width Adapt view to the width of the worksheet
Network  Print Print worksheet
Command Function
Removing nodes Remove the selected node from the network.
Set master (MN) Define node as Managing Node (MN).
• The master initialises the Ethernet Powerlink and carries out the associated
change of status from Pre-Operational to Operational.
• The node taking over the role of the Managing Node (MN) in the network view is
identified by a black triangle in the left corner at the bottom: