Lenze Engineer v2.21 - Manual (Page 255)

Lenze · Engineer · 2.13 EN - 10/2014
255
Error messages
Communication entity generator
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.4.4 I/O system IP20 (modular and compact)
Unexpected error [CEEPMT0001]
Error during writing of parameter value {0} [CEEPMT0002]
Transfer mode {0} is not supported [CEEPMT0003]
12.4.5 9400 PROFIBUS module
EXTENSION_BOARD_SLOT could not be entered in the control configuration [CE94PRF0001]
Error during creation of the EXTENSION_BOARD_SLOT Mappings/Code [CE94PRF0002]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Parameter value could not be written to the code.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The indicated transfer mode is not supported.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
For the indicated PROFIBUS module, a control
configuration module cannot be entered in the control
configuration.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
No mapping code can be generated for the PROFIBUS
module between the control configuration module and
the port variables.