Lenze Engineer v2.21 - Manual (Page 232)

Catalogue management in the »Engineer«
General information about catalogues
232
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11 Catalogue management in the »Engineer«
11.1 General information about catalogues
»Engineer« catalogues contain information about all types of elements for setting up »Engineer«
projects. The »Engineer« uses different catalogues which provide the types of information listed in
the below table.
Catalogue type Information contained
Device catalogue Descriptive information for the device types.
A device catalogue defines the standard device parameters with their
respective permissible value range for every device type (example: 9400
HighLine V04).
The device catalogue can also be used to store rules for module equipment,
data on existing on-board communication interfaces and additional
information about the respective device type.
Device module catalogue Descriptive information for types of device module (example:
communication module PROFIBUS 1.00).
A device module catalogue defines the module parameters with their
permissible value range for active device modules.
A device module catalogue can also contain details about communication
interfaces and additional functions of the respective device module type.
Application catalogue Technology applications (example: Speed actuating drive 3.0.3).
Technology applications can be integrated into »Engineer« projects and
used as a basis for own applications.
Depending on the device series the application catalogue is made for, the
application catalogue may include prepared programs, function block
interconnections or initial values for standard device parameters.
Function block (FB) catalogue Descriptive information about the function block types used in the FB Editor.
The function block catalogues are the basis for insertions into the FB
interconnections of the Servo Drives 9400 device series.
Lenze motor catalogue Descriptive information for the motor types produced by Lenze. The Lenze
motor catalogue defines the initial values to be set in the parameters of the
different controller types for the operation of the respective motor type.
User motor catalogue The user motor catalogue contains information similar to that of the Lenze
motor catalogue. The contents, however, can be defined individually by the
user. Therefore the handling of this catalogues differs in some points from
the handling of the other catalogues.
For further information, please see the following section:
 User motors ( 293)
Further catalogues Further catalogues contain information about networks, axes and
additional basic elements upon which the above-mentioned catalogues are
based and/or which can be used in »Engineer« projects.