Lenze Engineer v2.21 - Manual (Page 176)

Defining the system functionality
Inserting & configuring a machine application
176
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. Click the button to enter the selected application in the field on the right entitled
Selected applications & machine applications:
• By clicking the button, you can remove the application selected in the field entitled
Selected applications & machine applications and thus cancel the assignment to the
machine application.
• Already assigned logic modules are shown in grey in the field on the left entitled
Available applications & machine applications and cannot be assigned again.
3. Repeat the first two steps to assign further applications to the machine application.
8.13.2.2 Cancelling assignments

How to cancel an assignment:
1. Select the corresponding application (or machine application) in the field on the right
entitled Selected applications & machine applications.
2. Click the button.
• The selected application is then removed from the field entitled Selected applications &
machine applications and is thus no longer assigned to the machine application.