Lenze Engineer v2.21 - Manual (Page 250)

Error messages
Communication entity generator
250
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Transfer mode {0} is not supported [CESTD0006]
Error during writing of the SYNC master settings [CESTD0007]
Error during writing of the SYNC slave settings [CESTD0008]
PlugIn could not be found {0}[CEPLC0001]
PlugIn method could not be found {0} [CEPLC0002]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The indicated transfer mode is not supported.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The sync master settings could not be transferred to the
associated codes.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The sync slave settings could not be transferred to the
associated codes.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
A plug-in (PlugIn_DrivePlcDeveloperStudio) is needed for
generation of program code. This plug-in has probably
not been registered or there are version conflicts in
respect of catalogues and plug-in.
Install PlugIn.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
A plug-in (PlugIn_Drive PLC Developer Studio) is needed
for the generation of program code. This plug-in
evidently does not have the necessary method. There are
clearly version conflicts in respect of catalogues and
plug-in.
Install PlugIn.