Lenze Engineer v2.21 - Manual (Page 253)

Lenze · Engineer · 2.13 EN - 10/2014
253
Error messages
Communication entity generator
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Error during writing of parameter value {0} [CECOMP0006]
Transfer mode {0} is not supported [CECOMP0007]
Direction of transfer is not supported [CECOMP0008]
12.4.3 9400 On board
Node cannot be SYNC source and receiver at the same time [CE94CAN0001]
Deviating target version - This can bring about problems with regard to the compilation and the download (expected: {0}
[CE94CAN0002]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Parameter value could not be written to the code.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The indicated transfer mode is not supported.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The indicated direction of transfer (input, output) is not
supported.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Reserved
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The target version stored in the PLC Designer project of
the device specified does not comply with the version
expected by the generator. This can bring about
problems in particular if older PLC Designer projects are
imported.
This error message only is output in developer mode.
Change to the PLC programming tab and open the PLC
Designer project. In PLC Designer, choose and purge the
target system and compile the project again. The project
must be saved before exiting PLC Designer.