Lenze Engineer v2.21 - Manual (Page 240)

Error messages
Application Connection Generator
240
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Storage arrangement of the target port differs from the source port [AC0009]
Connection cannot be closed [AC0010]
Port variable size exceeds PDO data width. [AC0011]
No process data object available. [AC0012]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Ports with a different storage layout are tried to be
connected.
Example
Source: WORD, DWORD (6 bytes)
Target: BYTE, DWORD (6 bytes)
Only a differentiation with regard to the data width of
the element variable is made, but not with regard to the
type itself (sign/no sign or ANY_BIT types).
Check whether the connection of ports is intended.
Observe other data types in the application.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Node is not connected to the network.
An attempt is made to interconnect ports of various
devices that are not in a network.
Add all nodes to be interconnected to the same network.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The variable size of the port specified exceeds the
permissible data width for a CAN PDO.
Remove element variables from the port to reduce the
resulting data width of the port.  Defining element
variables for "Record" variable type ( 166)
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The interface used for connecting the node to the
network has an insufficiently high number of PDOs. It
cannot accept the port.
Either the setting of the PDOs does not allow for
automatic PDO configuration or the total number of
PDOs is too small.
Depending on the situation:
• ... Switch on automatic allocation for PDOs
• ... Perform manual PDO mapping
• ... Project additional interface