beautypg.com

2 baud rate and mmt master, Baud rate and mmt master, Error messages – Lenze Engineer v2.21 User Manual

Page 244

background image

Error messages

CAN generator

244

Lenze · Engineer · 2.13 EN - 10/2014

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Error during reading the address of nodes [NWCAN0005]

12.3.2

Baud rate and MMT master

Error during reading of node addresses [NWCAN0006]

Error during processing baud rate of object {0} [NWCAN0007]

No NMT master defined in the network! [NWCAN0008]

More than one NMT master defined in the network! [NWCAN0009]

Response (Lenze setting printed in bold)

Error  Warning  Information

Cause

Remedy

Response (Lenze setting printed in bold)

Error  Warning  Information

Cause

Remedy

A baud rate which is not supported has been set for the

node defined.

Set a different baud rate in the "Settings" tab of the

associated network.

Response (Lenze setting printed in bold)

Error  Warning  Information

Cause

Remedy

The access to the baud rate parameter has failed.

Response (Lenze setting printed in bold)

Error  Warning  Information

Cause

Remedy

In the indicated network no NMT master which transfers

the nodes to the Operational Mode has been defined.

Ignore warning if an external device takes over this

function.

Response (Lenze setting printed in bold)

Error  Warning  Information

Cause

Remedy

In the indicated network, several nodes have been

defined as NMT master. They switch the nodes to

Operational mode.

Ignore warning if this function is desired.