2 inhibit controller, 3 start application, 4 stop application – Lenze Engineer v2.21 User Manual
Page 101: Inhibit controller, Start application, Stop application, Inhibit controller ( 101), Start application ( 101), Stop application ( 101), Device functions with active online connection
Lenze · Engineer · 2.13 EN - 10/2014
101
Device functions with active online connection
Controlling an inverter: Enable/inhibit, start stop application
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2.2
Inhibit controller
How to set the controller inhibit:
1. Select the controller for which the controller inhibit is to be set in the Project view.
2. If no online connection to the device has been established yet:
Click the
icon or select the menu command Online Go online to establish an online
connection to the device.
3. Click the
icon or select the menu command Online Inhibit controller.
4. Confirm the safety query on whether the controller is to be inhibited with Yes.
• The controller then is inhibited.
• By clicking the
icon or via the menu command Online Enable controller you can
cancel the controller inhibit in the drive controller.
An active controller inhibit is displayed in the status bar:
7.2.3
Start application
How to start the application in the controller:
1. Select the controller for which the application is to be started in the Project view.
2. If no online connection to the device has been established yet:
Click the
icon or select the menu command Online Go online to establish an online
connection to the device.
3. Click the
icon or select the menu command Online Start application.
4. Confirm the safety query on whether the application in the controller is to be started with
Yes.
• Then the application in the controller is started.
• By clicking
or via the menu command Online Stop application you can stop the
application in the controller.
The application status is displayed in the status bar:
7.2.4
Stop application
How to stop the application in the controller:
1. Select the controller for which the application is to be stopped in the Project view.
Danger!
During commissioning persons must keep a safe distance from the motor or the
machine parts driven by the motor. Otherwise there would be a risk of injury by moving
machine parts.