Lenze Engineer v2.21 - Manual (Page 262)

Menu reference - Overview of the menu commands
"Application data" menu
262
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13.6 "Application data" menu
IP address configurator:
• PROFINET
• EtherNet/IP
Display/change IP settings:
PROFINET nodes at the local Ethernet segment
 PROFINET address configurator ( 97)
Ethernet nodes  EtherNet / IP addresses
configurator ( 97)
Status of the diagnostic
adapters
Display operating status of the diagnostic adapters
that are connected via the USB interface.
 Diagnostic adapter
Icon Command Shortcut Info
Icon Command Shortcut Info
Manage parameter sets
Comparing parameter sets -  Comparing parameter sets ( 139)
Copying parameter sets -  Copying parameter sets ( 143)
Managing function block interconnections
 Function block editor (FB Editor) ( 149)
Function block
interconnection ...
• ... compare
• ... copy
• ... insert
- Detailed information on the FB Editor for the Inverter
Drives 8400 and Servo Drives 9400 series can be
found in the documentation of the function library
for the corresponding device series.
Export/import function block
interconnection
- Import/export function block interconnection (XML
file)
• This function is available depending on the
device.
Compare ENP parameters
• This function is only
available when a
controller of the Servo
Drives 9400 series has
been inserted into the
project.
- Export the parameters of the selected project
element to an EDS / DCF file. EDS is a file format of
the Servo Drives 9400 device series.