Lenze Engineer v2.21 - Manual (Page 246)

Error messages
CAN generator
246
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Node does not support any SYNC slave functions [NWCAN0015]
Node does not support any SYNC master function [NWCAN0016]
Node is SYNC sender and receiver at the same time [NWCAN0017]
Object cannot be transferred. Node not a SYNC slave [NWCAN0026]
12.3.4 COB-ID
Stock of CAN IDs exhausted [NWCAN0018]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Node does not support a sync slave function.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Node does not support a SYNC master function.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Reserved
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
The node specified either operates with synchronised
process data objects or processes (tasks). However, the
node has not been declared as synchronisation object
receiver.
Make the following choice for the node in the
Synchronisation tab of the indicated network under
SYNC receivers:
• Transfer/receive synchronised process data objects
• Synchronise processes (tasks)
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Too many communication objects are transferred in the
indicated network.
Available COB-IDs are no longer provided.
• Reduce number of port connections
• Extend the COB-ID identifier range in the Settings tab
of the network specified.
Caution:
The default range is designed in a manner that also
enables old Lenze devices like 9300 and 8200 to operate
with it.