Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 744)

692 Brocade Network Advisor IP User Manual
53-1003153-01
Layer 2 access control list management
19
The Duplicate - Layer 2 ACL Configuration dialog box displays with the default name ‘Copy of
Original_Name’.
3. Enter a new name for the ACL in the Name field.
4. To edit an existing ACL rule, complete the following steps.
a. Select the rule you want to edit in the ACL Entries list and click the left arrow button.
b. Complete step 5 through step 12 in “Creating an extended Layer 2 ACL configuration
(Fabric OS)” on page 689.
The updated ACL entry displays in the ACL Entries list. To edit additional ACL entries,
repeat
step 4 .
5. To add a new ACL rule, complete step 4 through step 12 in “Creating an extended Layer 2 ACL
configuration (Fabric OS)” on page 689.
The new ACL entry displays in the ACL Entries list. To add additional ACL entries, repeat step 5 .
6. To delete an existing ACL rule, select the rule you want to edit in the ACL Entries list and click
the left arrow button.
7. Click OK on the Duplicate - Layer 2 ACL Configuration dialog box.
The new ACL displays in the ACL Entries list. To copy additional ACLs, repeat step 2 through
step 7 .
8. Click OK on the Device_Name - Layer 2 ACL Configuration dialog box.
The Deploy to Products - Layer 2 ACL dialog box displays. To save the configuration, refer to
“Saving a security configuration deployment” on page 750
Assigning a Layer 2 ACL configuration to an interface (Fabric OS)
To assign Layer 2 ACL configuration to a interface, complete the following steps.
1. Select Configure > Security > Layer 2 ACL > Port.
The Port Selection - Layer 2 ACL dialog box displays.
2. Select a port or Link Aggregation Group (LAG) in the Available Ports list and click the right arrow
button.
LAGs display in the Available Ports list using the following convention: Po LAG_Number.
3. Click OK.