Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1304)

1252 Brocade Network Advisor IP User Manual
53-1003153-01
Configuration rules
37
15. To remove a condition or block from a rule, select one or more conditions and blocks in the
Selected Conditions/Blocks list and click the left arrow button.
16. Click OK on the Add Configuration Rule dialog box.
17. Click OK on the Add Monitor dialog box.
The updated configuration policy manager displays in the Monitors table of the Configuration
Policy Manager dialog box.
18. Click Close on the Configuration Policy Manager dialog box.
Duplicating a configuration rule
You can create a new configuration rule based on a predefined or user-defined configuration rule.
1. Select Monitor > Configuration Policy Manager.
The Configuration Policy Manager dialog box displays.
2. Click Add.
The Add Monitor dialog box displays.
3. Click the Switch/Router Checks tab.
4. Select the configuration rule (either predefined rule or user-defined) you want to duplicate in
the Available Checks list or Selected Checks list.
5. Click Add > Configuration Rule.
The Add Configuration Rule dialog box displays.
6. Change the name for the rule in the Name field.
The name cannot be over 128 characters. The only special characters allowed are an
underscore (_) or space.
7. Change the description for the rule in the Description field.
The description cannot be over 1024 ASCII characters.
8. To edit the configuration rule, repeat step 7 through step 15 of “Adding a configuration rule” on
page 1250.
9. Click OK on the Add Configuration Rule dialog box.
10. Click OK on the Add Monitor dialog box.
The updated Configuration Policy Manager displays in the Monitors table of the Configuration
Policy Manager dialog box.
11. Click Close on the Configuration Policy Manager dialog box.
Editing a configuration rule
You can edit your own rules to compare content against a baseline.
1. Select Monitor > Configuration Policy Manager.
The Configuration Policy Manager dialog box displays.
2. Click Edit.