Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 568)

516 Brocade Network Advisor IP User Manual
53-1003153-01
SMI Agent Configuration Tool
13
4. Type # Install_Home/cimom/bin/slptool findsrvs service:wbem and press Enter to verify the
SLP service is advertising its WBEM services.
5. Choose one of the following options to verify the SLP service is advertising the WBEM SLP
template over its configured client protocol adapters.
• Type # Install_Home/cimom /bin/slptool findattrs service:wbem:http://IP_Address:Port
and press Enter.
• Type # Install_Home/cimom /bin/slptool findattrs service:wbem:https://IP_Address:Port
and press Enter.
NOTE
Where IP_Address:Port is the IP address and port number that display when you use the
slptool findsrvs service:wbem command.
SLP on Windows systems
This section describes how to verify the SLP daemon on Windows systems.
SLP file locations on Windows systems
• SLP log — Install_Home\cimom \cfg\slp.log
• SLP daemon — Install_Home\cimom\cfg\slp.conf
You can reconfigure the SLP daemon by modifying this file.
• SLP register — Install_Home\cimom\cfg\slp.reg
You can statically register an application that does not dynamically register with SLP using
SLPAPIs by modifying this file. For more information about these files, read the comments
contained in them, or refer to http://www.openslp.org/doc/html/UsersGuide/index.html.
Verifying SLP service installation and operation on Windows systems
1. Launch the Server Management Console from the Start menu.
2. Click Start to start the SLP service.
3. Open a command window.
4. Type cd c:\Install_Home\cimom \bin and press Enter to change to the directory where slpd.bat
is located.
5. Type > slptool findsrvs service:service-agent and press Enter to verify the SLP service is
running as a Service Agent.
6. Type > slptool findsrvs service:wbem and press Enter to verify the SLP service is advertising its
WBEM services.
7. Choose one of the following options to verify the SLP service is advertising the WBEM SLP
template over its configured client protocol adapters.
• Type > slptool findattrs service:wbem:http://IP_Address:Port and press Enter.
• Type > slptool findattrs service:wbem:https://IP_Address:Port and press Enter.
NOTE
Where IP_Address:Port is the IP address and port number that display when you use the
slptool findsrvs service:wbem command.