Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 1355
Brocade Network Advisor IP User Manual
1303
53-1003153-01
Event action definitions
38
2. Click Next to advance to the Sources pane.
3. Click the Provide the IP Address / Node WWN / Name of the source button if you want to
manually enter the IP address, the world wide name (WWN), or the name of the source in the IP
Address field.
4. Click the Select from the available list of sources button as an alternative to manually entering
the IP address, WWN, or name of the source. You can select source address products or ports
to use as event senders from the available list of sources.
5. Select the Use If index in source matching check box if you want to use if Index to filter traps on
a specific port of a product; otherwise, the filter is applied globally on a product.
6. If the Use IfIndex in source matching check box is selected, select the varbind to be used from
the Trap Varbind (IfIndex) list.
7. Select the event senders you want from the Available Sources list, then click the right arrow
button to move them in the Selected Sources list.
•
If you selected a non-IronWare OSNetwork OSproduct as the source, that product can send
e-mail alerts only.
•
If you selected Pseudo Events from the Events pane of the Add Event Action dialog box,
and there is only one pseudo event available, double-click the pseudo event in the
Available Sources list.
•
If you selected a product group or port group as event senders, select a group from the list.
NOTE
The selected source count cannot exceed 100.
8. Click Next.
The Policy pane of the Add Event Action dialog box displays. Proceed to