Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 1181
Brocade Network Advisor IP User Manual
1129
53-1003153-01
IP historical performance monitoring
34
The Data Collector wizard Collector Basics dialog box displays where you can add values
for a new collector.
FIGURE 471
Data Collector wizard Collector Basics dialog box
3. Enter a descriptive name for the data collector in the Name field.
4. Use the Polling Interval list to set the polling interval.
The choices are 1 minute, 5 minutes, 10 minutes, 15 minutes, and 30 minutes.
5. Select the Target Type.
•
If you select Product level, SNMP data is collected at the product (device) level.
•
If you select Port level, SNMP data is collected at the port level.
6. Select the Status of the collector.
•
If you select Enabled, the data collector starts collecting data immediately.
•
If you select Disabled, the data collector stops collecting data.
•
If you select Schedule, you may set up a time schedule for running the data collector.
The following options become active when you select Schedule:
•
Frequency - This list allows you to run the data collector on a Yearly, Monthly, Weekly, Daily,
Hourly, or One Time basis. Appropriate options are displayed allowing you to set a start
time and duration for data collection.
•
If you select Yearly, or One Time, the Time (hh:mm) and Date selectors display.
•
If you select Monthly, the Time (hh:mm) and Day of the Month selectors display.