Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 615)

Brocade Network Advisor IP User Manual 563
53-1003153-01
Ethernet fabric traceroute
15
4. Choose one of the following options:
• Assign appropriate RBridge ID — Select this option to use Address Finder to identify the
RBridge ID of the source.
The Management application finds the RBridge ID on which the MAC address is learned.
• Select RBridge ID — Select this option to select an RBridge ID from the list of the RBridge
IDs currently present in the cluster.
Before you select an RBridge ID from the list, you must know on which RBridge ID the MAC
address is learned.
5. Select a VLAN from the VLAN list.
Valid values are from 1 through 3583.
NOTE
Both the source and destination must be on the same VLAN.
To customize the traceroute packet, continue with step 6 .
To start the traceroute, go to step 14 .
6. Select the Advanced options check box.
7. Choose one of the following options from the IP Protocol Type list:
• TCP
• UDP
8. Enter a source IP address (IPv4 only) in the Source IP field.
9. Enter a source port number in the Source Port field.
Valid values are from 0 through 65535.
10. Enter a destination IP address (IPv4 only) in the Destination IP field.
11. Enter a destination port number in the Destination Port field.
Valid values are from 0 through 65535.
12. Enter the number of times you want to repeat the traceroute request on the fabric in the
Repeat Trace Route field.
Valid values are from 1 through 10. The default is 1. There is a one-second delay between the
requests.