Configuring a one-time discovery schedule – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 130
76
Brocade Network Advisor IP User Manual
53-1003153-01
IP discovery profiles
3
•
To configure discovery to run only once, refer to
“Configuring a one-time discovery
•
To configure hourly discovery, refer to
“Configuring an hourly discovery schedule”
•
To configure daily discovery, refer to
“Configuring a daily discovery schedule”
•
To configure weekly discovery, refer to
“Configuring a weekly discovery schedule”
•
To configure monthly discovery, refer to
“Configuring a monthly discovery schedule”
•
To configure yearly discovery, refer to
“Configuring a yearly discovery schedule”
5. Rearrange schedules in the Scheduled Discovery Cycles list by selecting an item in the list and
clicking the Up or Down buttons to move it.
6. Click Apply to save your changes.
7. Click Close to close the Discover Setup - IP dialog box.
8. Click Yes on the confirmation message.
Configuring a one-time discovery schedule
To configure a one-time discovery schedule, complete the following steps.
1. Select One Time from the Frequency list.
FIGURE 29
Scheduling tab - One Time
2. Select the time of day you want discovery to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click the Date list to select a date from the calendar.
4. Click the right arrow button to add the schedule to the Scheduled Discovery Cycles list.