Adapters faulty sfp report – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 1448
1396
Brocade Network Advisor IP User Manual
53-1003153-01
Host adapter reports
41
Adapters Faulty SFP report
The Adapters Faulty SFP report lists all Brocade adapters with unsupported or faulty small
form-factor pluggable (SFP) transceivers. This report is only available for Brocade adapters.
For adapters with unsupported SFPs, this report is the same as the Adapters Inventory report
filtered to show only those hosts with adapter ports that have unsupported SFPs. For a complete
list of fields and components of the Adapters Inventory report, refer to the
For adapters with degrading SFPs, there are additional columns in the table that show the
SFP/SFP+ and pluggable optical module (POM) properties for the degrading SFP.
describes the SFP and POM fields of the Adapters Faulty SFP Report.
Media
The type of media; for example, 8G-sw (8 Gbps software).
FC Address
The port’s Fibre Channel address.
Fabric Name
The name of the Fabric.
Zone Alias
The alternate name of the zone.
Fabric Assigned Address
The state (enabled, disabled, or N/A) of the fabric assigned address for the adapter.
WWN Source
The source of the world wide name. Options include:
Fabric — The WWN is assigned from the fabric. The fabric assigned address must be
enabled.
Factory — The WWN is assigned at the factory.
N/A — Not applicable.
Boot Over SAN
Whether Boot over SAN is enabled or disabled.
Max Supported Speed
The maximum speed that is supported on the port. For the FC port, the maximum
speed is 8 Gbps.
Status
The status of the Ethernet port; for example, Linkup or Linkdown.
TABLE 128
Adapters Faulty SFP report fields and components
Field/Component
Description
SFP Supported
Whether the SFP is supported or not.
Connector Type
The type of port connector; for example, LC. SC, or Cu (copper cable).
Transceiver
The type of transceiver; for example, SFP or SFP+.
Media
The type of media for the transceiver; for example, single mode.
Speed
The port speed.
Extended ID
The identifier for the extended link.
Encoding
Displays how the extended link is encoded, for example, 8B10B.
Baud Rate
The transmission rate, roughly equivalent to the number of bits per second.
Length 9U1
The length of the single-mode fiber-optic cable, used in situations where gigabit
performance is not required (for distances greater than 100 meters).
Length 9U2
The length of the single-mode fiber-optic cable, used in situations where gigabit
performance is not required (for distances greater than 100 meters).
TABLE 127
Adapters Inventory report fields and components (Continued)
Field/Component
Description