Configuration rules, Configuration rules 6, Viewing a predefined – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 1298: Configuration rule, Viewing a predefined configuration rule, Predefined configuration rules
1246
Brocade Network Advisor IP User Manual
53-1003153-01
Configuration rules
37
Configuration rules
A configuration rule is a logical expression built with configuration conditions and blocks. You can
use configuration rules to perform a configuration compliance check against a baseline (such as a
product’s backup configuration file).
Viewing a predefined configuration rule
You can view detailed information about predefined configuration rules on the Add Monitor or Edit
Monitor dialog box.
1. Select the predefined configuration rule you want to view.
The configuration rule displays in the Details area.
2. Review the configuration rule.
For specific detailed information about the predefined rules, refer to
Predefined configuration rules
The Management application provides the following predefined configuration rules:
•
No Interface Shutdown Rule — The rule fails when any interface (10 Gbps port or LAG) on the
device shuts down.
defines the logical expressions for this rule.
•
Port Profile Interface Rule — The rule fails when any interface (10 Gbps port or LAG) on the
device does not have a port profile.
defines the logical expressions for this rule.
TABLE 101
No Interface Shutdown Rule expressions
AND/OR ( Block/Condition Name
) Details - Description/Condition/Configuration
Start: Network OS Ten Gigabit
Ethernet Interfaces
Processes all 10 Gigabit Ethernet interfaces on a Network
OS device.
interface TenGigabitEthernet .*
Network OS Interface NOT
shutdown
Condition test fails if the interface is shut down.
Not Matches - Lines in any order
shutdown
End: Network OS Ten Gigabit
Ethernet Interfaces
!
AND
Start: Network OS LAG
Interfaces
Processes all LAG interfaces on a Network OS device.
interface Port-channel .*
Network OS Interface NOT
shutdown
Checks whether the interface is configured as shutdown.
This condition should be used within an interface block.
Not Matches - Lines in any order
shutdown
End: Network OS LAG
Interfaces
!