Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 126)

72 Brocade Network Advisor IP User Manual
53-1003153-01
IP discovery profiles
3
Adding IP addresses
To add an IP address range (IPv4 and IPv6), complete the following steps.
1. Select IP Address from the Entry Type list.
FIGURE 24 Include Address Range
2. Enter the first IP address in the range in the first IP Address field.
3. Enter the last IP address in the range in the second IP Address field.
4. To exclude an address range using the IP Address format, refer to “Excluding IP addresses” on
page 73.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 70.
Excluding CIDR subnet addresses
To exclude CIDR subnet addresses (IPv4 and IPv6), complete the following steps.
1. Select CIDR Subnet from the Entry Type list.
FIGURE 25 Exclude CIDR Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask bits in the Subnet Mask Bits field.
For IPv4, the subnet mask bits is between 0 and 32.
For IPv6, the subnet mask bits is between 0 and 128.
4. To include an address range using the CIDR Subnet format, refer to “Adding CIDR subnet
addresses” on page 71.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 70.