7 configuration examples, Networking requirements, Configuration roadmap – Nortel Networks 8000 User Manual
Page 88: Data preparation, Configuration procedure, 9 configuration examples -30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
4 POS and CPOS interface configuration
Action
Command
Set the local loopback in the T1
channel of the STM-1 CPOS
interface.
t1
tl-number
set loopback { local | payload | remote }
4.7 Configuration examples
This section provides the following examples:
•
Example for directly connecting routers through POS interfaces
•
Example for configuring STM-1 CPOS interfaces
4.7.1 Example for directly connecting routers through POS
interfaces
Networking requirements
You need to directly connect the POS interfaces of Router A and Router B with a pair of
single mode optic fiber (receiving, sending) through PPP.
Figure 4-5 Networking diagram of connecting routers directly through POS interfaces
POS1/0/0
10.110.1.10/24
POS4/0/0
10.110.1.11/24
RouterA
RouterB
Configuration roadmap
The configuration roadmap is as follows:
1.
Configure the link layer protocol to PPP.
2.
Configure the IP address.
Data preparation
To connect routers directly through POS interfaces, you need the following data:
•
The IP address of POS 1/0/0 of Router A is 10.110.1.10/24.
•
The IP address of POS 4/0/0 of Router A is 10.110.1.11/24.
Configuration procedure
Step 1 Configure Router A.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
4-27