Configuration procedures – Nortel Networks 8000 User Manual
Page 327
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
8 Frame relay configuration
Configuration procedures
No.
Procedure
1
Configuring IPHC on an frame relay main interface
2
Configuring IPHC on an freame relay P2MP sub-interface
3
8.10.2 Configuring IPHC on an frame relay main interface
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Choose one of the following steps to enter the corresponding interface view as required.
•
Run the
interface
interface-type interface-number command to enter the FR main
interface view.
•
Run the
interface mfr
interface-number command to enter the MFR interface view.
Step 3
Run:
fr compression iphc
The command enables IPHC on the interface.
Step 4
Run:
fr iphc { nonstandard | rtp-connections numberl | tcp-connections number2 | tcp-include }
The command enables the IPHC function.
—End
ED NOTE
•
You perform step 3 and step 4 regardless of the sequence.
•
After disabling IPHC by using the
undo fr compression iphc
command, the configuration of Step 4
still takes effect. After you re-enable IPHC by using the
fr compression iphc
command, parameters
you configured in step 4 remain effective.
8.10.3 Configuring IPHC on an freame relay P2MP sub-interface
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Choose one of the following steps to enter the corresponding interface view as required.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
8-37